Ultimate Polish System MEGA Bundle - #1 Compound, #2 Polish, #3 Wax, #4 Shine & Holder

Please see below for detailed  instructions on use...

• Firstly, apply and allow your chosen clear coat to dry for the manufacturers specified time.
• Using 6000/8000/12000 grit Micromesh (dependent upon the severity of the flaws in the paint work), lightly sand back/flatten the finish, removing dust and defects as required.
• Depending on the result after sanding/flattening, decide whether you need to use #1 Compound or skip to #2 Polish.  Deeper scratches/marks will require #1 Compound, whilst less intrusive marks will only need #2 Polish.

Ultimate Compound #1

1. Lightly moisten a polishing cloth with clean water.
2. Apply a very small amount of Compound #1 to the cloth.
3. Apply to your model in "crosshatch motions" (straight up and down, then side to side), applying gentle pressure.  Be careful of raised areas and paintwork edges so as not to "burn" through the paintwork!
4. Once applied, remove residue with a clean polishing cloth.
5. Remove any excess dried Compound #1 with an old or soft toothbrush.
6. Repeat from step 1 if required or continue to Ultimate Polish #2 if you're happy with the result.

Ultimate Polish #2

1. Lightly moisten a polishing cloth with clean water.
2. Apply a very small amount of Polish #2 to the cloth.
3. Apply to your model in "crosshatch motions" (straight up and down, then side to side), applying gentle pressure.  Be careful of raised areas and paintwork edges so as not to "burn" through the paintwork!
4. Once applied, remove residue with a clean polishing cloth.
5. Remove any excess dried Polish #2 with an old or soft toothbrush.
6. Repeat from step 1 if required or continue to Ultimate Wax #3 if you're happy with the result.

Ultimate Wax #3

1. Lightly moisten an polishing cloth with clean water.
2. Apply a very small amount of Wax #3 to the cloth.
3. Apply to your model in a circular motion giving even coverage and applying gentle pressure.  Be careful of raised areas and paintwork edges so as not to "burn" through the paintwork!
4. Once dry, remove residue with a clea polishing cloth and buff to a high shine.
5. Remove any excess dried Wax #3 with an old or soft toothbrush.

Ultimate Shine #4

1. Spray a small amount directly to an polishing cloth.
2. Apply to your model in a circular motion giving even coverage and applying gentle pressure.
3. Once dry, remove residue with a clean polishing cloth and buff to a high shine.
4. You can use Shine #4 to give a fresh shine to models as and when required.

PLEASE NOTE - These products have a shelf life of approximately 12-18 months once opened.

If you have any question at all or are unsure of any step of the process, please free to contact us for clarification.

*Polishing cloth not included